No.04593949AA Manifold Absolute Pressure MAP Sensor for Jeep Grand Cherokee

No.04593949AA Manifold Absolute Pressure MAP Sensor for Jeep Grand Cherokee

SKU: AT-NZ5X272WF
No reviews
$13.28
Vehicle fitment & details
  • Vendor REPAIROCK
  • SKU AT-NZ5X272WF
  • Fits makes
    • Chrysler
    • Dodge
    • Jeep
  • Fits models
    • 300
    • Challenger
    • Charger
    • Compass
    • Grand Caravan
    • Grand Cherokee
    • Journey
    • Patriot
    • Town & Country
    • Wrangler
    • for Ram 1500 2500 3500 4500 5500
  • Model years
    • 2011
    • 2012
    • 2013
    • 2014
    • 2015
    • 2016
    • 2017
    • 2018
  • OE numbers
    • 04593949AA
    • 04593949AB
    • 68525698AA

Do you have questions about this product?

Ask an expert!

Description Shipping information Reviews
Fitment:
  • for Jeep Grand Cherokee 2011-2017
  • for Jeep Compass 2012-2017
  • for Jeep Patriot 2012-2017
  • for Jeep Wrangler 2012-2017
  • for Dodge for Ram 1500 2500 3500 4500 5500 2011-2017
  • for Dodge Journey 2012-2018
  • for Dodge Charger 2012-2017
  • for Dodge Challenger 2012-2017
  • for Dodge Grand Caravan 2013-2017
  • for Chrysler 300 2012-2017
  • for Chrysler Town & Country 2012-2016
OE Number:
  • 04593949AA/04593949AB/68525698AA
Product Characteristics:
  • This MAP sensor is used to calculate air density and determine the engine's air mass flow rate and provides instantaneous manifold pressure information to the engine's electronic control unit. As the MAP sensor fails, it can cause various issues with the fuel system and vehicle performance.
  • Direct replacement and installation without special tools, convenient to use.
Package included:
  • 1 Pc MAP Sensor
Installation:
  • 1.Install: Remove old sensor; mount new in engine bay (passenger side).
  • 2.Vacuum Wiring: Connect to BOV source; route wires through firewall to door; link to MAP power (note signal).
  • 3.ECU: Plug into ports (see manual); ECU under p-side carpet.
  • 4.Bypass: Splice new power/ground to factory; insulate old signal; connect new to UTEC.
  • 5.Calibrate: In UTEC (Edit Maps>Params>Special), input intercept/gradient per manual's voltage/pressure.
  • 6.Test: To drive and check loose/solder issues.
Note:
  • This is a non-OEM product, accessory ONLY!
  • Please make sure your model's ENGINE and TRIM are as described before purchasing!