No.32700065 Manifold Absolute Pressure MAP Sensor for Harley Davifor DSon FLHR

No.32700065 Manifold Absolute Pressure MAP Sensor for Harley Davifor DSon FLHR

SKU: AT-NZ5WE9BHR
No reviews
$14.57
Vehicle fitment & details
  • Vendor FUELHOOD
  • SKU AT-NZ5WE9BHR
  • Fits makes
    • Harley-Davidson
  • Fits models
    • Davifor DSon FLHR Road King
    • Davifor DSon FLHRXS Road King Special
    • Davifor DSon FLHT Electra Glide Standard
    • Davifor DSon FLHTK Ultra Limited
    • Davifor DSon FLHTKL Ultra Limited Low
    • Davifor DSon FLHX Street Glide
    • Davifor DSon FLHXS Street Glide Special
  • Model years
    • 2017
    • 2018
    • 2019
    • 2020
  • OE numbers
    • 32700065

Do you have questions about this product?

Ask an expert!

Description Shipping information Reviews
Fitment:
  • for Harley Davifor DSon FLHR Road King 2017-2020
  • for Harley Davifor DSon FLHRXS Road King Special 2017-2020
  • for Harley Davifor DSon FLHT Electra Glide Standard 2019-2020
  • for Harley Davifor DSon FLHTCU Electra Glide Ultra Classic 2017-2019
  • for Harley Davifor DSon FLHTK Ultra Limited 2017-2020
  • for Harley Davifor DSon FLHTKL Ultra Limited Low 2017-2019
  • for Harley Davifor DSon FLHX Street Glide 2017-2020
  • for Harley Davifor DSon FLHXS Street Glide Special 2017-2020
OE Number:
  • 32700065
Product Characteristics:
  • This MAP sensor is used to calculate air density and determine the engine's air mass flow rate and provides instantaneous manifold pressure information to the engine's electronic control unit. As the MAP sensor fails, it can cause various issues with the fuel system and vehicle performance.
  • Direct replacement and installation without special tools, convenient to use.
Package included:
  • 1 Pc MAP Sensor
Installation:
  • 1.Install: Remove old sensor; mount new in engine bay (passenger side).
  • 2.Vacuum Wiring: Connect to BOV source; route wires through firewall to door; link to MAP power (note signal).
  • 3.ECU: Plug into ports (see manual); ECU under p-side carpet.
  • 4.Bypass: Splice new power/ground to factory; insulate old signal; connect new to UTEC.
  • 5.Calibrate: In UTEC (Edit Maps>Params>Special), input intercept/gradient per manual's voltage/pressure.
  • 6.Test: To drive and check loose/solder issues.
Note:
  • This is a non-OEM product, accessory ONLY!
  • Please make sure your model's ENGINE and TRIM are as described before purchasing!