No.32MPP1602 Manifold Absolute Pressure MAP Sensor for ISUZU Elf 2014
No.32MPP1602 Manifold Absolute Pressure MAP Sensor for ISUZU Elf 2014
No.32MPP1602 Manifold Absolute Pressure MAP Sensor for ISUZU Elf 2014
No.32MPP1602 Manifold Absolute Pressure MAP Sensor for ISUZU Elf 2014
No.32MPP1602 Manifold Absolute Pressure MAP Sensor for ISUZU Elf 2014
No.32MPP1602 Manifold Absolute Pressure MAP Sensor for ISUZU Elf 2014
No.32MPP1602 Manifold Absolute Pressure MAP Sensor for ISUZU Elf 2014
No.32MPP1602 Manifold Absolute Pressure MAP Sensor for ISUZU Elf 2014
No.32MPP1602 Manifold Absolute Pressure MAP Sensor for ISUZU Elf 2014
No.32MPP1602 Manifold Absolute Pressure MAP Sensor for ISUZU Elf 2014
No.32MPP1602 Manifold Absolute Pressure MAP Sensor for ISUZU Elf 2014
No.32MPP1602 Manifold Absolute Pressure MAP Sensor for ISUZU Elf 2014

No.32MPP1602 Manifold Absolute Pressure MAP Sensor for ISUZU Elf 2014

SKU: AT-NZ8EXSU3Z
No reviews
$13.78
Vehicle fitment & details
  • Vendor RATCHROLL
  • SKU AT-NZ8EXSU3Z
  • Fits makes
    • Isuzu
  • Fits models
    • Elf
  • Model years
    • 2014
  • OE numbers
    • 32MPP1602

Do you have questions about this product?

Ask an expert!

Description Shipping information Reviews
Fitment:
  • for ISUZU Elf 2014
OE Number:
  • 32MPP1602
Product Characteristics:
  • This MAP sensor is used to calculate air density and determine the engine's air mass flow rate and provides instantaneous manifold pressure information to the engine's electronic control unit. As the MAP sensor fails, it can cause various issues with the fuel system and vehicle performance.
  • Direct replacement and installation without special tools, convenient to use.
Package included:
  • 1 Pc MAP Sensor
Installation:
  • 1.Install: Remove old sensor; mount new in engine bay (passenger side).
  • 2.Vacuum Wiring: Connect to BOV source; route wires through firewall to door; link to MAP power (note signal).
  • 3.ECU: Plug into ports (see manual); ECU under p-side carpet.
  • 4.Bypass: Splice new power/ground to factory; insulate old signal; connect new to UTEC.
  • 5.Calibrate: In UTEC (Edit Maps>Params>Special), input intercept/gradient per manual's voltage/pressure.
  • 6.Test: To drive and check loose/solder issues.
Note:
  • This is a non-OEM product, accessory ONLY!
  • Please make sure your model's ENGINE and TRIM are as described before purchasing!