No.A0061539828 Manifold Absolute Pressure MAP Sensor for MERCEDES-BENZ B-Class

No.A0061539828 Manifold Absolute Pressure MAP Sensor for MERCEDES-BENZ B-Class

SKU: AT-NZ8Q41ILR
No reviews
$14.38
Vehicle fitment & details
  • Vendor A ABSOPRO
  • SKU AT-NZ8Q41ILR
  • Fits makes
    • Jeep
    • Mercedes-Benz
  • Fits models
    • A-Class (W169) A200 2.0 Turbo
    • B-Class (W245) B200 2.0 Turbo
    • Grand Cherokee II 2.7 CRD 4x4
  • Model years
    • 2001
    • 2002
    • 2003
    • 2004
    • 2005
    • 2006
    • 2007
    • 2008
    • 2009
    • 2010
    • 2011
    • 2012
    • 2013
    • 2014
  • OE numbers
    • A0061539828
    • 0261230192
    • 0041533128
    • 0041533328
    • 0051537228
    • 0061531428
    • A0041533128

Do you have questions about this product?

Ask an expert!

Description Shipping information Reviews
Fitment:
  • for MERCEDES-BENZ C-Class Saloon (W204) C180 C200 1.8 Kompressor 2007-2014
  • for MERCEDES-BENZ B-Class (W245) B200 2.0 Turbo 2005-2011
  • for MERCEDES-BENZ A-Class (W169) A200 2.0 Turbo 2006-2012
  • for MERCEDES-BENZ E-Class T-modell (S211) E200 1.8 Kompressor 2003-2009
  • for JEEP Grand Cherokee II 2.7 CRD 4x4 2001-2005
OE Number:
  • A0061539828/0261230192/0041533128/0041533328/0051537228/0061531428/A0061539828/A0041533128
Product Characteristics:
  • This MAP sensor is used to calculate air density and determine the engine's air mass flow rate and provides instantaneous pressure information to the engine's electronic control unit. As the MAP sensor fails, it can cause various issues with the fuel system and vehicle performance.
  • Direct replacement and installation without special tools, convenient to use.
Package included:
  • 1 Pc MAP Sensor
Installation:
  • 1. Install: Remove old sensor; mount new in engine bay (passenger side).
  • 2. Vacuum & Wiring: Connect to BOV source; route wires through firewall to door; link to MAP power (note signal).
  • 3. ECU: Plug into ports (see manual); ECU under p-side carpet.
  • 4. Bypass: Splice new power/ground to factory; insulate old signal; connect new to UTEC.
  • 5. Calibrate: In UTEC (Edit Maps>Params>Special), input intercept/gradient per manual's voltage/pressure.
  • 6. Test: To drive and check loose/solder issues.
Note:
  • This is a non-OEM product, accessory ONLY!
  • Please make sure your model's ENGINE and TRIM are as described before purchasing!