No.MHK100820L Manifold Absolute Pressure MAP Sensor for LAND ROVER Discovery

No.MHK100820L Manifold Absolute Pressure MAP Sensor for LAND ROVER Discovery

SKU: AT-NZ87HAN3J
No reviews
$14.52
Vehicle fitment & details
  • Vendor A ABSOPRO
  • SKU AT-NZ87HAN3J
  • Fits makes
    • Land Rover
    • MINI
  • Fits models
    • Defender Off-Road 2.5 Td5 4x4 L316
    • Discovery II 2.5 Td5 4x4
    • Freelander 1.8 16V 4x4
    • Hatchback (R50, R53) 1.6 Cooper
    • Hatchback (R50, R53) 1.6 Cooper S
  • Model years
    • 1998
    • 1999
    • 2000
    • 2001
    • 2002
    • 2003
    • 2004
    • 2005
    • 2006
    • 2007
    • 2008
    • 2009
    • 2010
    • 2011
    • 2012
    • 2013
    • 2014
    • 2015
    • 2016
  • OE numbers
    • MHK100820L
    • 12140872648
    • MHK100820

Do you have questions about this product?

Ask an expert!

Description Shipping information Reviews
Fitment:
  • for LAND ROVER Discovery II 2.5 Td5 4x4 1998-2004
  • for LAND ROVER Defender Off-Road 2.5 Td5 4x4 L316 1998-2016
  • for LAND ROVER Freelander 1.8 16V 4x4 1998-2006
  • for MINI Hatchback (R50, R53) 1.6 Cooper 2001-2006
  • for MINI Hatchback (R50, R53) 1.6 Cooper S 2002-2006
OE Number:
  • MHK100820L/12140872648/MHK100820
Product Characteristics:
  • This MAP sensor is used to calculate air density and determine the engine's air mass flow rate and provides instantaneous pressure information to the engine's electronic control unit. As the MAP sensor fails, it can cause various issues with the fuel system and vehicle performance.
  • Direct replacement and installation without special tools, convenient to use.
Package included:
  • 1 Pc MAP Sensor
Installation:
  • 1. Install: Remove old sensor; mount new in engine bay (passenger side).
  • 2. Vacuum & Wiring: Connect to BOV source; route wires through firewall to door; link to MAP power (note signal).
  • 3. ECU: Plug into ports (see manual); ECU under p-side carpet.
  • 4. Bypass: Splice new power/ground to factory; insulate old signal; connect new to UTEC.
  • 5. Calibrate: In UTEC (Edit Maps>Params>Special), input intercept/gradient per manual's voltage/pressure.
  • 6. Test: To drive and check loose/solder issues.
Note:
  • This is a non-OEM product, accessory ONLY!
  • Please make sure your model's ENGINE and TRIM are as described before purchasing!